Brochure

800-543-9038 USA 866-805-7089 CANADA 203-791-8396 LATIN AMERICA
1-34
PC-Tool User Manual
If the address MP1 is already assigned to an actuator, a message will be displayed:
Message when the address MP1 is alread
y assigned (limited lot)
Click OK to initially release the address MP1. The actuator that used to be assigned to this
address will be set to PP.
Click Cancel to stop the parameterization at this point.
Identification with known serial numbers
You can also fill in the input boxes manually before you click "Parameterize", for example when
the buttons of the actuator are not accessible or you regularly take the serial numbers from your
documents.
Programming further series
The actuators that have been successfully programmed are deleted from the list. You can
register further serial numbers in the list and then click "Start parameterization" again.
M40035 - 05/10 - Subject to change. © Belimo Aircontrols (USA), Inc.