User's Manual

23
Alternate Setup Method
23
section
1
2
3
4
5
6
7
8
9
10
11
Setting your ISP Connection Type to Static IP
A static IP address connection type is less common than other
connection types. If your ISP uses static IP addressing, you will
need your IP address, subnet mask, and ISP gateway address. This
information is available from your ISP or on the paperwork that your
ISP left with you. Type in your information then click “Apply Changes”
(5). After you apply the changes, the “Internet Status” indicator will
read “connection OK” if your Router is set up properly.
(1) IP Address
Provided by your ISP. Enter your IP address here.
(2) Subnet Mask
Provided by your ISP. Enter your subnet mask here.
(3) ISP Gateway Address
Provided by your ISP. Enter the ISP gateway address here.
(4) My ISP Provides More Than one Static IP Address
If your ISP assigns you more than one static IP address, your Router
is capable of handling up to five static WAN IP addresses. Select
“My ISP Provides more than one Static IP address” and enter your
additional addresses.
(1)
(2)
(3)
(4)
(5)