Network Router User Manual

4948
Manually Configuring your Router
4948
Allow Incoming ICMP Echo Requests: Choose this box if you want to
allow ping or traceroute commands under DOS prompt.
Allow Incoming UDP Traceroute Queries: Choose this box if you want
to allow UDP traceroute requests.
System Settings
The “System Settings” page is where you can enter a new administrator
password, set the time zone, and turn on and off the UPnP function of
the Router.
Setting or Changing the Administrator Password
The Router ships with NO password entered. If you wish to add a
password for greater security, you can set a password here. Write
down your password and keep it in a safe place, as you will need it if
you need to log into the Router in the future. It is also recommended
that you set a password if you plan to use the remote management
feature of your Router.
Changing the Login Time-Out Setting
The login time-out option allows you to set the period of time that you
can be logged into the Router’s advanced setup interface. The timer
starts when there has been no activity. For example, you have made
some changes in the advanced setup interface, then left your computer
alone without clicking “Logout”. Assuming the time-out is set to three
minutes, then three minutes after you leave, the login session will expire.
You will have to log into the Router again to make any more changes.