User manual

Hookup and Installation
PureAV Power Console
Step 3
Remote DC Operation
This function allows you to turn your Power Console on and off via any
component that is equipped with a 3~30V DC output (low-voltage trigger out).
Note: You cannot turn off the switched outlets on the Power Console
with the switched button on the front of the unit when there is any
external power signal supplied to either the AC or DC remote inputs.
To install the Remote DC Control Cable:
A. Connect the Remote DC Control Cable (included) into the outlet labeled
“DC IN” on the rear panel of the Power Console. (Fig. 3a)
B. Press the “Remote” button on the front of the Power Console to turn
on the remote function. The "Remote ON" indicator should be lit. (Fig. 3b)
C. Press the “Switched” button on the front of the Power Console to turn
off the switched outlets.
D. Connect the other end of the Remote DC Control Cable into the 3~30V
output (low-voltage trigger out) on your component. When you turn on
the component the outlets on the Power Console programmed as
“Switched” will be turned on immediately and the “Switched/ Delayed”
outlets will come on after an 8 second delay.
8
Figure 3a Figure 3b