User manual

2322

Advanced Setup Method

section

Password Settings

Use this page to restrict access based on a password. By default, the

password is “admin”.

Passwords can contain from 3 to12 alphanumeric characters which

are case sensitive.

Note: If your password is lost, or you cannot gain access to the

user interface, press the reset button (colored blue) on the rear

panel (holding it down for at least 20 seconds) to restore the factory

defaults. (By default the password is “admin”)

Enter a maximum Idle Time Out (in minutes) to define a maximum

period of time an inactive login session will be maintained. If the

connection is inactive for longer than the maximum idle time, it will be

logged out, and you will have to login to the web management system

again. (Default: 10 minutes)

Remote Management

By default, management access is only available to users on your

local network. However, you can also manage the VoIP Router from

outside your network via remote management by checking the

Enabled check box. You can set a HOST ADDRESS, which will only

Status (Page 82)

• Provides WAN connection type and status, firmware and

hardware version numbers, system IP settings, as well as DHCP,

NAT, and firewall information.

• Displays the number of attached clients, the firmware versions,

the physical MAC address for each media interface, and the

hardware version and serial number.

• Shows the security and DHCP client log.

System Settings

Time Settings

Set the time zone and time server for the VoIP Router. This

information is used for log entries and client access control.

Check “Enable Automatic Time Server Maintenance” to automatically

maintain the VoIP Router’s system time by synchronizing with a

public time server over the Internet. Then configure two different time

servers by selecting the options in the Primary Server and Secondary

Server fields.