User manual

7372
Advanced Setup Method
Advanced Setup Method
73
section
2
1
3
4
5
6
7
Dialing Plans
Configure the VoIP dialing plans on this page, and click “SAVE
SETTINGS”.
Set the Phone Number and Connection Type on this page.
VoIP Status and Call Logs
View the VoIP status for both FXS ports on this page. Click “Refresh”
to update this page.
analogue call. Disable this if you are experiencing issues with phone
system menus, Faxing over IP etc.
Default/recommended = Enabled
PLC
Packet Loss Compensation. PLC is used only when utilising the
G.711 codec, the algorithm is designed to compensate for loss
packets. Re-transmitting the lost packets is obviously not a viable
option with a digital VoIP telephone call.
Default/recommended = Enabled
Caller ID Mode
Use DTMF Caller ID Mode. Enabling this option enables the Dual
Tone, Multi-Frequency (touch tone) mode for Caller ID.
Default/recommended = Disabled
Inter Digit Delay
This is the delay time before processing the dialled digits. This will
delay the VoIP unit dial the telephone number after the digits have
been entered.
Default/recommended = 4 Seconds
Additional Ringing Mode
Enabling this option will force the VoIP telephone to ring when an
incoming call is made through via the PSTN number. You will need to
have a filtered telephone cable connected to the PSTN Failover.
Default/recommended = Enabled
T.38 Mode
T.38 is the standard for sending faxes over IP networks. Enable this
option for Faxing over IP.
Default/recommended = Enabled