Conserve Valet Smart USB Charging Station ™ User Guide
A charger left plugged into the wall can still draw power—even when no device is attached. The Conserve Valet Smart USB Charging Station charges up to four devices at once and shuts off automatically. The product itself draws zero power when not in use—so you can keep your devices ready to go without wasting energy. non-slip device surface start button LED power indicator For more information and to learn about other Belkin Conserve energy management products, please go to belkin.
Quick Setup Guide 1 Plug in your USB device cords that you want to use with your Conserve Valet Smart USB Charging Station. NOTE: We advise you to use the USB cable that came with your mobile device. If your device did not come with a USB cable, please refer to your manufacturer for availability. We have included a USB to Mini-USB Cable and a USB to Micro-USB Cable, which might work with your devices. 2 Wind your USB cords around the inner spool of your Conserve Valet to manage the cords.
Plug the AC power cord into your Conserve Valet and plug the other end into a power outlet. 5 Connect your devices to their respective USB cords and place them on the Conserve Valet pad. 6 Press the light-green power button and the LED will illuminate; power is now flowing to your devices.
7 Once all connected devices are charged (approximately 4 hours), the LED light will flash 3 times and your Conserve Valet will power down. If you connect an additional device during charging, the Valet will restart the charge time to ensure that the new device is fully charged before powering down. If you unplug all your devices, the Valet will automatically power down after 2 minutes. NOTE: When sitting idle, the Conserve Valet uses no power.
Troubleshooting My device does not charge when connected to the Conserve Valet. Check that your Conserve Valet is securely plugged into a power outlet. Next you’ll want to make sure that any device attached to your Conserve Valet is securely connected at both ends. Ensure that the start button has been depressed and that the Conserve Valet’s LED is green. If your device does not begin to charge, disconnect the Conserve Valet and your device and reconnect them as described in the Quick Setup Guide.
What will we do to correct problems? Conserve Valet Warranty. Belkin will repair or replace, at its option, any defective Conserve Valet free of charge (except for shipping charges for the Conserve Valet). Belkin reserves the right to discontinue any of its products without notice, and disclaims any limited warranty to repair or replace any such discontinued products.
Use Energy Wisely Using electricity or driving a car does have an effect on the environment, but by using energy wisely we can prevent waste and reduce carbon dioxide (CO2) emissions. CO2 is a greenhouse gas that accumulates in the Earth’s atmosphere, trapping heat from the sun and keeping the planet warm. CO2 comes, in part, from the burning of fossil fuels, such as coal and gasoline, to generate electricity for use in our homes and to power our cars.