User manual

15
Belkin® Advanced Secure DisplayPort KVM
INSTALLATION
SECTIONSTable of Contents 1 2 3 4 5 6 7 83
BACK TO TABLE OF CONTENTS >
INSTALLATION
SECTIONSTable of Contents 1 2 3 4 5 6 7 83
Step 3 Connecting Computers to the Switch
3.1 Make sure all computers are powered off.
3.2 Using the Belkin DP/USB KVM Cable Kit (sold separately), connect
the computers to a port on the rear of the KVM Switch.
Step 4 Powering Up the Computers
Power up all the attached computers, and check for display
and peripheral functionality. All computers can be powered on
simultaneously.
Note: Your computers should recognize the Switch and
automatically install the HID USB driver if necessary.
When you power on your computers, the Switch emulates both a
mouse and keyboard on each port and allows your computers to boot
normally. The computer connected to port “1” will be displayed on
the monitor. Check to see that the keyboard, monitor, and mouse are
working normally. Proceed to do this with all occupied ports to verify
that all computers are connected and responding correctly. If you
encounter an error, check your cable connections for that computer
and reboot. If the problem persists, please refer to the Troubleshooting
section in this User Manual.
Note: The Cable Kit must be connected directly to a free USB port
on your computer with no USB hubs or other devices in between.