Specifications

Authored by Simon Adams Product Support Specialist Canon UK RCC
Revision 1.2 © Canon 2006
15
You will now need to make sure your router is set up correctly. Here we will be setting up a the Belkin 4
port router, however the settings should be similar on other makes of router however you may need a
different IP address to get to the access point’s administration screen, so refer to your router’s manual
for this. The Belkin’s administration screen is located at 192.168.2.1, so we will open an internet
explorer window and type the IP address into the URL bar. You will need to login to your router (consult
your router’s manual for the username and password)
The only setting you need to ensure you have set up on this screen is DHCP server on, as this will issue
an IP address to the WFT-E1A automatically from the available pool of addresses. Once again, ensure
that you have not set your computers IP address that is running the FTP server to fall within this range
of addresses or a conflict will occur.
If you have a hardware based firewall activated in your router, you must make sure port 21 is forwarded
through this firewall or communications from the WFT-E1A will be blocked. Contact your router
manufacturer for assistance with port forwarding if this is the case.