Operation Manual

23
Alternate Setup Method
23
section
2
1
3
4
5
6
7
8
9
10
11
1.5 Turn your cable or DSL modem on by reconnecting the power
supply to the modem.
Note: Your Router may have ports in different locations than
depicted in the illustration above.
1.6 Before plugging the power cord into the Router, plug the cord
into the wall, then plug the cord into the Router’s power jack.
1.7 Verify that your modem is connected to the Router by checking
the lights on the front of the Router. The green light labeled
“WAN” should be ON if your modem is connected correctly to the
Router. If it is not, recheck your connections.
1.8 Verify that your computer is connected properly to the Router
by checking the lights labeled “LAN 1,2,3,4”. The light which
corresponds to the numbered port connected to your computer
should be ON, if your computer is connected properly. If it is not,
recheck your connections.
To Power Adapter
Mac or PC computer that was originally
connected to the cable or DSL modem
Network cable
(to computer)
Existing networking cable
(came with modem)