Other Content

The QODE App can update the firmware on your Belkin QODE™ Ultimate Pro
Keyboard Case for iPad Air (App enabled), F5L171 and Belkin QODE™ Ultimate
Pro Keyboard Case for iPad Air 2 (App enabled), F5L176.
IMPORTANT: Before using your Belkin QODE Keyboard, make sure to disconnect
the Bluetooth® devices previously connected to it. Also, if the keyboard layout of
your device is different from that of your Hardware Keyboard, you must change
the keyboard language to update the output. Modifying only the iPad® or mobile
phone language will not change the keyboard output. For more information on
how to change this on your Android™ device, click here. For more information on
how to change this on your iOS device, click here.
NOTE: The QODE App will prompt if there is an updated firmware available.
Before proceeding with the firmware update, you need to do the following setup
steps.
Step 1:
Reboot the QODE Keyboard by holding the four corner keys down for 5 seconds
until the light flashes red and blue alternately.
Step 2:
Remove keyboard pairing from iPad. You can do this by going to Settings >
Bluetooth. Under My Devices, tap Forget This Device.
Step 3:
Fully shut down the App then relaunch. To do this, tap the home button twice to
enter multitasker. Swipe left or right to find the QODE Update App and swipe up.
NOTE: You may need to repeat these setup steps if the update process fails.
After completing the setup steps above, proceed with the steps below to update