User Manual

High Speed ADSL2+
Modem
Quick Installation Guide
Setup Overview
1 Hardware Connections
Step A
Place the modem next to the computer. Connect the Modem’s power cord into the
back of the Modem. Connect a telephone cable from the wall into the back of the
Modem.
If your computer has an Ethernet (network) connection, continue with section B1.
Alternatively you can install the Modem with a USB connection, continue with section B2.
Step B1
Find your new networking cable (it came in the box with your Modem) and connect it to
the LAN port on the back of the modem.
Connect the other end to your computers LAN port.
Please continue to Step 2
Thankyou for purchasing a Belkin Modem, you will need to run through the following steps once to set up your Modem.
Hardware Connections:
Use the instructions in this Guide
to connect your Modem to your
computer.
Confi guring your
Modem:
Confi gure your Belkin Modem
with the easy-to-use Web Based
Setup Utility
Connecting to the Internet
1
2
3
It’s as easy as 1-2-3
Ethernet Setup
Step B2
Insert the CD into your computer.
Windows ME (or later) users: Connect the Modem to your computer with a USB cable.
Windows 98SE users: Please refer to the user manual located on the CD for further
instructions.
Please continue to Step 2
USB Setup






Step A
Open your Internet Browser (Internet Explorer, FireFox, Netscape, Safari etc) In
the Address Bar, type in 10.1.1.1. You will be presented with a Login screen, type in
“admin” as the password then click LOGIN
Note: The password is case sensitive.
2 Confi guring your Modem