10-Outlet Surge Protector Quick Start Guide

ManualsBrandsBelkin ManualsSurge ProtectorPM01629

©2008BelkinInternational,Inc.Allrightsreserved.Alltradenamesareregisteredtrademarksofrespectivemanufacturerslisted.PM01629•BG108000

Conserve Energy-Saving Surge

Protector with Remote Switch

Quick Start Guide

IMPORTANT – READ BEFORE INSTALLING

Summary of content (4 pages)

PAGE 2
Step 1: Plug equipment into “Always On” outlets. These outlets are for devices that need continuous power, such as: • Digital video recorders • Cordless phones Wireless Wireless routers Wireless Router Router Cordless Cordless Cordless Phone phones • Alarm clocks • Wireless routers Computer Computer Monitor Monitor Phone 1 Printer Printer Step 2: Scanner Plug equipment into “Remote Switched”Scanner outlets.
PAGE 3
Step 3: Plug Conserve power cord into the wall outlet. Step 4: Remove the remote switch and wall-mount from the box. Mounting screws are not included; see User Guide for wall-mount installation. Step 5: Pull and remove the clear battery tab from the back of the remote switch. Remove before using.
PAGE 4
Step 6: Firmly press and release the “|” button to turn ON the “Remote Switched” outlets. Check to see if a green light flashes on the remote switch. This will indicate that the remote is working. 6 I = ON O = OFF Step 7: Your equipment is now powered, surge-protected, and ready for use. Step 8: When finished using your equipment, turn off each device as you normally would.