User manual

1
1. Getting @TV connected to your home network
The @TV setup software for PC and Mac is the best way to configure @TV.
Visit http://www.belkin.com/mytveverywhere to download the software.
a.Wired
i. Direct connection via an Ethernet cable will provide the best possible
performance for your @TV product. Simply connect the cable to one of
the open ports on your broadband-connected network router and then
to the Ethernet port on your @TV.
ii. If you have trouble getting your @TV to connect with your router, first
make sure that the network cables are attached properly to both
devices. Then try restarting your router or cable/DSL modem: unplug
the devices for 30 seconds, plug them back in, and they should find
one another.
b.Wireless
i. In order to get your @TV onto your home wireless network, follow the
directions in the setup software.
ii. If your router is WPS (Wi-Fi Protected Setup) enabled, you can
also follow your router’s instructions for how to connect devices
to it using that feature; this will not always work for all router/@TV
combinations, but should work for most. The red @TV WPS button
is located on the right side of the product as you face it, just next to
the USB service port.
SETUP AND INSTALLATION