Submittal Sheet
SUBMITTAL
A-331
JOB:
REPRESENTATIVE:
UNIT TAG:
ORDER NO.
DATE:
ENGINEER:
SUBMITTED BY:
DATE:
CONTRACTOR:
APPROVED BY:
DATE:
Primary/Secondary Header
Model PSH
DESCRIPTION
The B&G low-
loss header, Model PSH, is a combination air separator and
manifold that creates independent primary and secondary circuits. The B&G
Model PSH is equipped with a purge valve allowing the user to remove any
debris deposited on the bottom of the vessel and an air vent releasing
trapped air in the system
CONSTRUCTION
Connection
1",1-1/4' and 1-1/2" threaded female
2",2-1/2", 3" and 4" ANSI 150 CLASS Flange
Material
Body: Steel
Air Vent: Brass
Drain Valve: Brass
Insulation-Threaded: PEX
Insulation-Flange: Polyurethane Foam
MODEL
NUMBER
PART
NUMBER
CONNECTION
SIZE(INCHES)
MAX
FLOW GPM (m³/h) TAGGING INFORMATION QUANTITY
PSH-1 112465 1 11 (2.5)
PSH-1.25 112466 1-1/4 18 (4)
PSH-1.5 112467 1-1/2 26 (6)
PSH-2 112468 2 40 (9)
PSH-2.5 112469 2-1/2 80 (18)
PSH-3 112470 3 124 (28)
PSH-4 112471 4 247 (56)
TYPICAL SPECIFICATIONS
Furnish and install as shown on plans a ______-
inch primary/secondary header with insulation. The header shall be designed for maximum
operating pressure of 150 PSI at a maximum operating temperature of 210°F/220°F/230°
F. The header shall function as a combination air
separator and manifold that creates independent primary and secondary circuits. The header body shall be made of steel and equipped with
brass air vent and drain valve.
The primary/secondary header shall be ITT Bell & Gossett Model No. PSH-______.
© COPYRIGHT 2006 ITT, Corporation
Bell & Gossett