Install Instructions

1
2
3
4
5
6
7
8
1. Coverplate 5. Seal assembly
2. Gasket 6. Wave spring
3. Seat gasket 7. Retaining screws
4. Seat 8. Bearing cap
Figure 7: Large bearing assembly
Remove the seal
1. Remove the spring retainer and seal spring.
2. Pry the compression ring off the seal boot.
3. Insert a standard screwdriver under the seal head and carefully pry the seal head off
the shaft.
Do not scratch the shaft sleeve.
4. Use a small screwdriver in order to loosen and remove the seal seat and gasket.
5. If the seat retainer is in good condition, leave it in the faceplate. If it is in bad condition,
pry it out and replace it with the new one provided in the seal kit.
Maintenance
24 Series 60 Installation, Operation, and Maintenance Manual