Install Instructions

1
2
3
4
5
6
7
8
1. Coverplate 5. Seal assembly
2. Gasket 6. Wave spring
3. Seat gasket 7. Retaining screws
4. Seat 8. Bearing cap
Figure 7: Large bearing assembly
6.1.5 Remove the seal
1. Remove the spring retainer and seal spring.
2. Pry the compression ring off the seal boot.
3. Insert a standard screwdriver under the seal head and carefully pry the seal head off
the shaft.
Do not scratch the shaft sleeve.
4. Use a small screwdriver in order to loosen and remove the seal seat and gasket.
5. If the seat retainer is in good condition, leave it in the faceplate. If it is in bad condition,
pry it out and replace it with the new one provided in the seal kit.
6.2 Pre-assembly inspections
Guidelines
Before you assemble the pump parts, make sure you follow these guidelines:
• Inspect the pump parts according to the information in these pre-assembly topics
before you reassemble your pump. Replace any part that does not meet the required
criteria.
• Make sure that the parts are clean. Clean the pump parts in solvent in order to remove
oil, grease, and dirt.
6 Maintenance
20 Series e-60 INSTRUCTION MANUAL