User guide

ManualsBrandsBell & Gossett ManualsAccessories for waterG97035G Readout Valve, Readout Probe

Readout Valve

RV-125A

(G97030)*

RP-250B

(G97032)*

*SET OF TWO *SET OF TWO

FERRULE

NUT

*SET OF TEN

Readout Probe

INSTALLER: PLEASE LEAVE THIS MANUAL FOR THE OWNER’S USE.

NOTE: This product is not intended for use in potable water applications.

WARNING: California Proposition 65 Warning! This product contains chemicals known to the State of California to

cause cancer and birth defects or other reproductive harm.

SAFETY

INSTRUCTIONS

This safety alert symbol will be used in this man-

ual to draw attention to safety related instruc-

tions. When used, the safety alert symbol means

ATTENTION! BECOME ALERT! YOUR SAFETY IS IN-

VOLVED! FAILURE TO FOLLOW THESE INSTRUCTIONS

MAY RESULT IN A SAFETY HAZARD.

DESCRIPTION

The Readout Valve is equipped with an inte-

gral EPDM rubber check valve designed to mini-

mize system fluid loss when used with a RP-

250B Readout Probe to monitor pumps, heat exchang-

ers, valves, etc., handling hot or cold water.

CONNECTION SIZE

Readout Valve: 1/8" NPT and 1/4" NPT

Readout Probe: 7/16" – 20 UNF-2A THD Meter Connection

V58050PK*

PROTECTIVE

CAP

BODY

1/8" NPT 1/4" NPT

CHECK

VALVE

OPERATIONAL LIMITS

Working Pressure 300 PSIG

Temperature 250°F

INSTALLATION INSTRUCTIONS

WARNING: Hot fluids and/or flu-

id under pressure. Isolate the prod-

uct in which the readout valve is to be in-

stalled with shut off valves, or drain the sys-

tem. Make sure that all drainage from the sys-

tem has stopped and that the system tempera-

ture has cooled to 100° F or less. Vent off any pres-

sure prior to installation. Failure to follow these instruc-

tions could result in serious personal injury or death

and property damage.

1. Apply pipe joint compound to NPT end of read-

out valve body and install into NPT opening.

2. Tighten cap on top of the readout valve.

3. Repressurize the system.

INSTRUCTION MANUAL

G97035G

Summary of content (2 pages)

PAGE 1
INSTRUCTION MANUAL G97035G Readout Valve Readout Probe V58050PK* RV-125A (G97030)* RP-250B (G97032)* PROTECTIVE CAP BODY 1/8" NPT 1/4" NPT FERRULE NUT CHECK VALVE *SET OF TWO *SET OF TEN *SET OF TWO INSTALLER: PLEASE LEAVE THIS MANUAL FOR THE OWNER’S USE. NOTE: This product is not intended for use in potable water applications.
PAGE 2
OPERATING INSTRUCTIONS WARNING: Potential for escape of hot fluids. Use only B&G companion readout probes to obtain accurate and safe readout from the readout valve. Failure to follow these instructions could result in serious personal injury or death and property damage. WARNING: Hot fluids may escape. When monitoring system flow, care must be exercised to avoid skin or eye contact with liquids that may escape.