Installation guide

2
First, you must identify which satellite dish you currently have. Of the two
satellite dishes shown below, identify the one that resembles the satellite dish
you have based on its overall SIZE, and the LIKENESS of the satellite dish arm.
Next, determine how many satellite receivers will be connected to the satellite dish.
If you encounter any problems when installing your Bell ExpressVu Multi-Satellite
Dish Antenna Upgrade Kit, or have any questions regarding these new satellite
dish components, you are welcome to contact Bell ExpressVu directly at
1 888 SKY-DISH (759-3474).
46 centimetre Satellite Dish with one LNBF
(available before October, 2002)
Dish Upgrade instructions begin on page 3
51 centimetre Satellite Dish with one
LNBF and expansion slot (available after
September, 2002)
Dish Upgrade instructions begin on page 9
Up-to-two receiver set-up
After completing Dish Upgrade,
consult page 11 for wiring instructions
Three-to-four receiver set-up
After completing Dish Upgrade, consult page 13 for wiring
instructions
Upgrade of original 46 cm Satellite dish with new 51cm
Multi-Satellite dish
The components in your Upgrade Kit which will you use in this section are:
– a 51 centimetre satellite dish
– satellite dish arm with Y-adapter
– one LNBF (low noise amplifier)
– coaxial cables
1. Remove original 46 cm satellite dish by completing the following steps:
a) Detach LNBF from satellite dish arm by loosening LNBF screw
b) Disconnect LNBF from the coaxial cable located in satellite dish arm and
set the LNBF aside for now, you will need it for later for the upgrade
installation
c) Loosen mast clamp bolts located on the back of the satellite dish.
d) Dismount satellite dish from mast by lifting it upwards, taking care that
the coaxial cable pulls away from the dish arm and is left protruding out
the top of the dish mast.
3
Mast Clamp
Bolts
Coaxial
Cable
Dish Screws
Mast
Dish Bolts
Y-Bracket
Getting Started Dish Upgrade
2. Assemble new 51 cm Multi-Satellite Dish by attaching mount plate bracket to
the back of the satellite dish with supplied screws and bolts. Attach Y-adapter
bracket to dish support arm using Y-bracket screw and nut.
Y-Bracket Screw and Nut has
fine thread, 1 set each