Installation guide

10
Upgrading current 51 cm Multi-Satellite dish with
second LNBF
4. Power on one of your satellite receivers and display the ‘Point Dish’ screen on
the TV by pressing ‘Menu’ on the remote and selecting the ‘System Set-up’
option, then ‘Installation’ and finally select ‘Point Dish/Signal’. You will see
one of the two screens displayed below.
You have now completed the ‘Dish Upgrade’ and can now proceed to the
‘Wiring Upgrade’:
• If you are wiring your satellite system for up to two receivers,
go to page 11
• If you are wiring your satellite system for three-to-four receivers,
go to page 13
‘Single satellite’ screen ‘Dual satellite’ screen
Ensure ‘Satellite’ is set to Nimiq 91–
message will indicate “Wrong Satellite”
Ensure ‘Satellite’ is set to
‘Bell ExpressVu 82’
Dish Upgrade
Wiring for up to two receivers
At this stage, you should already have a 51 cm Multi-Satellite dish mounted the
top of your mast with two LNBF’s attached to the Y-adapter located at the end of
the dish arm. Also, you should have conducted tests to ensure the satellite dish is
aimed in the proper direction to receive both Bell ExpressVu satellite signals at
optimum strength. If this is not the case, do not proceed with these ‘Wiring
Upgrade’ instructions until you complete the ‘Dish Upgrade’ section.
The components in your Upgrade Kit which will you use in this section are:
– Two 2:1 multi-switches (SW21)
– Four coaxial cables
1. Remove both LNBF’s from the Y-adapter at the end of the satellite dish arm.
2. Starting from the back of the dish assembly, slowly thread two coaxial cables
(not included) through the inside of the satellite dish arm until the cables
protrude through the opening of the Y-adapter labeled 91°. Label these
cables at 91° to help identify them when connecting them later.
3. Take either LNBF, connect the cables to each of its outputs and insert the LNBF
into 91° slot on the Y-adapter. Tighten LNBF screw and bolt.
4. At the back of the dish assembly, thread the other two coaxial cables through
the inside of the satellite dish arm until the cables protrude through the
opening of the Y-adapter labeled 91°. Label these cables at 91° to help identify
them when connecting them later.
11
Wiring Upgrade
Y-Bracket