Installation guide

Wiring for up to two receivers
5. Connect cables to each output of the remaining LNBF and insert it into 82°
slot on the Y-adapter. Tighten LNBF screw and bolt.
6. Take the cables leading from the LNBF in the 91° Y-adapter slot and connect
each one to the ‘Dish 1’ input of each 2:1 multi-switch.
7. Take the cables from the 82° LNBF and connect each one to the ‘Dish 2’ input
of each 2:1 multi-switch.
12
8. Connect the cable(s) that will go inside the home to the output(s) of each 2:1
multi-switch
9. Mount each 2:1 switch to the brackets and attach the brackets to the back of
the dish assembly.
10. You have now completed the ‘Wiring Upgrade’ and can now proceed to the
‘System Set-up’ section on page 15.
13
Wiring for three-to-four receivers
At this stage, you should already have a 51 cm Multi-Satellite dish mounted top of
your mast with two LNBF’s attached to the Y-adapter located at the end of the dish
arm. Also, you should have conducted tests to ensure the satellite dish is pointed in
the proper direction to receive both Bell ExpressVu satellite signals at optimum
strength. If this is not the case, do not proceed with these ‘Wiring’ instructions
until you return and complete the Multi-Satellite dish upgrade section.
The components in your Upgrade Kit which will you use in this section are:
– one 4:4 multi-switch (SW44)
1. Remove both LNBF’s from the end of the satellite dish arm.
2. Starting from the back of the dish assembly, slowly thread two coaxial cables
(not included) through the inside of the satellite dish arm until the cables
protrude through the opening of the Y-adapter labeled 91°. Label these cables at
91° to help identify them when connecting them later.
3. Take either LNBF, connect the cables to each of its outputs and insert the LNBF
into 91° slot on the Y-adapter. Tighten LNBF screw and bolt.
Wiring UpgradeWiring Upgrade