Specifications

bellissimo 2-72 Way Video Entry System
PD-098 Issue 3C Installation and Operating Manual Page 14 of 40
Installation & Commissioning
Checklist
The following checklist is a summary of what is required. Refer to the relevant pages for
further details.
● Review the section headed ‘Safety Information’ on page 39.
● Ensure that ‘Design Considerations’ on page 9 have been understood.
● Confirm that Cat5 cable has been specified.
● Install the system according to instructions in this section.
● Check/set the door controller jumper and switch settings.
● Check/set the video controller jumper and switch settings.
● Check/set each videophone dipswitch settings.
Wiring
Refer to the diagrams from page 28 onwards as appropriate for the equipment you have.
All wiring is carried out using a mixture of Cat5 for the signal wiring and 1mm² (or greater)
cores for the power wiring; refer to Page 12 for further details. It is strongly recommended
that a consistent colour code be used throughout such as that indicated on the connection
diagram. Certain signals must be interconnected using a twisted pair from the Cat5 cable.
These are clearly marked on the connection diagram and should be strictly observed.
Entrance Panel
The panel should be mounted at an optimum height of 1.6 m, measured between the
ground and the centre of the camera window. With flush mounting panels it is advisable to
apply mastic to the top and side edges of the panel to prevent water ingress behind the
panel, but not to the bottom edge. On construction sites the panel must be protected from
corrosive substances such as ‘brick acid’. The panel should be cleaned only with a damp
cloth containing dilute detergent.
Videophone
The videophone is designed to be wall mounted onto
plasterboard or other masonry at an optimum height of 1.6m.
It should be fixed with three No 8 screws (not supplied). Use
the dimensions shown on the adjacent diagram. If the cable
is to be feed from the wall cavity then make a hole for this at
the same time. Fit the top two screws but do not fully tighten.
Now remove the top cover of the videophone, which is
secured by clips at both sides. If top or bottom cable entries
are required, careful remove the appropriate cutout with side
snips taking care not to damage any internal components.
Hang the videophone on the two screws already fitted
allowing the cable (if present) to feed through and the third
screw to be inserted at the bottom. Tighten all three screws. Before replacing the Front
Cover remove the protective film from the display lens and also check that the DipSwitch
settings are correct or change as necessary (see Page 22).
188.5mm
207mm