Owner's manual

8 9
before riding. We recommend cleaning the eye shield with a soft eece
cloth before you put on the helmet to make sure you can clearly see in
front of you while riding.
HELMETS WITH CAMERA MOUNT
CARING FOR YOUR HELMET
Cleaning: Helmets can be damaged by many available cleaners,
especially Petroleum based solvents. Clean the helmet using a soft cloth or
sponge, warm water and mild soap.
Storage: Excessive heat can damage the helmet. In direct sunlight,
dark gear bags and automobile trunks can get hot enough to cause heat
damage. Damaged helmets will appear to have uneven or bubbly surfaces.
WARNING: DO NOT use heat damaged helmets.
WARRANTIES
Bell
®
warrants to the original purchaser of this product that the product is
free of defects in material and workmanship for a period of one year from
the original date of purchase. This warranty does not apply to defects of
physical damage resulting from abuse, neglect, improper repair, improper
t, alterations, or use unintended by the manufacturer.
to overall comfort and helmet stability while riding. Make any minor
adjustments to the t pads and straps to improve comfort or stability.
HELMETS WITH VISORS
Some helmets come with removable Snap-On visors.
To remove visor, follow these steps:
A. Pull the ends of the visor loose from the helmet
and then lift away from the helmet.
B. To replace the visor, center it on the helmet and
then snap the pins (A) on the visor into the holes
(B) in the helmet, Figure 18.
Some Bell
®
helmets come with a Variable Position
Visor (VPV) or a Goggle Compatible Visor. These visors
offer a vertical angle adjustment by simply tilting the
visor up or down to the desired position (Figure 19).
CAUTION: DO NOT try to remove the visor by pulling
forward on the center. This will damage the helmet and the visor.
HELMETS WITH EYE SHIELD
Removing and attaching the eye shield:
The Javelin
™
comes with an eye shield attached to the helmet. To
remove, grab the eye shield directly below one of the outside snaps and
pull it straight down from the helmet. Then grab the eye shield directly
below the snap on the other side and pull it straight down from the
helmet. Repeat this process with the last snap in the center. To reattach
the shield, reverse this process by pushing the snap on the eye shield
directly into the snap basket in the helmet starting from the center, and
then insert the snap on one side, and then the other. Please make sure
all three snaps on the eye shield are securely attached to the helmet
Figure 18
Figure 19