Installation guide

Installation Guide
Page I-58
PROGRAM THE REMOTE
For certain models of Bell ExpressVu receivers you can program the remote to control not
only the receiver, but your VCR, TV, and amplifiers. This remote supports most brands and
models; however, there may be some brands or models that it does not support. You can
program the remote to control a maximum of four different electronic components. Which
component is being controlled by the remote depends on the current mode of the remote:
• The satellite receiver (controlled in SAT mode)
• The TV set (controlled in TV mode)
• A VCR (controlled in VCR mode)
• One auxiliary item, such as an amplifier, a cable TV box, or a second TV or VCR
(controlled in AUX mode).
Before beginning the following procedures, make sure that all electronic components are
powered ON. Make sure that there are fresh batteries installed in the remote.
The remote is already programmed to control the receiver. However, if any of the following
conditions apply, you will need to match the remote’s address to the receiver’s address:
• You have multiple receivers and remotes.
• Your receiver does not respond to remote commands (even with fresh batteries
installed in the remote).
• Your remote is damaged and replaced with a new unit.
For instructions on how to do this, as well as for full instructions for your remote
control, please refer to your User Manual.
9200_Ins_eng 5/18/05 8:34 AM Page 62