Specifications

15
Operational Features (front panel)
Mains switch
On/ off switch for normal- and standby operation. ‚ON‘ is indicated by the backlights of
the LCD displays.
Level Control (CH.A / B)
Sets the input signal damping in ‚dB‘. The actual setting is shown in the display.
[View Mode , Page 1] damping: max 88dB, min. 0.0dB.
Remote Active switch with led indicator
Activates the remote control mode. ( red Led (on)).
The remote control mode works in parallel to a ‚fade in‘ function to avoid harsh level
offsets.
Remote Control Mode*
Enables the remote control and supervision of the SCA2MR /4MR using an external
control unit. Data exchange via RS485 port. All necessary parameters are to be
selected in [Command Mode, page 1].
This mode may be disabled by the user.
[Command Mode, Page 4]. When remote control is active, the „command mode“ will be
automatically deactivated to avoid software conflicts.
*this function is not activated in software release 1.0
Command switch (with led indicator)
Switches at any time from „Command“- to „View Mode“ and reverse.
„Command Mode on“ is indicated by an addition green led indicator. When leaving
„Command Mode“ any manipulation of parameters will automatically be safed, even
when ‚Enter‘ was not operated.
„Command Mode“ section may be protected by a keycode (numeric password).
[Command Mode , Page 5]
Re.: functions of „Command“- und „View Mode“
Page/Exit button
Jumps to the next page ( in „Command“- and „View Mode“) Any manipulation of
data will automatically be safed without operating ‚Enter‘ button.
Set/Enter
By pushing the wheel, the „Enter“ order is executed. Turning the wheel to either
direction will activate the ‚Set‘ function.
Enter
In Command Mode pressing ‚Enter‘ will jump from parameter to parameter. Any
manipulation of data will automatically be stored. The next parameter to be modified is
shown in cursor mode. Press enter for each new digit to be stored.