Installation Guide

13
Pic. 3.5 Pic. 3.6 Pic 3.7
If you have (2) internal trims you must cut the panels 1 ¼” shorter than the wall to wall measurements
from left to right. You will then slide the panel all the way into the left channel (pic. 3.8) and then
position the right side at the channel and slide it in about ½ way (pic. 3.9) keeping the left side in the
channel as well (pic. 3.10).
Pic 3.8 Pic. 3.9 Pic. 3.10
Dry fit the Lower Level Valve Wall to make sure it fits the top of the panel meeting the line on the wall
of the Design Strip. Plus, the panel needs to align with the outside line of the wall. If using an outside tub
leg, the piece needs to have a snug fit to the tub/pan. Make sure that the tub spout and valve holes align
properly (pic. 3.11).
Pic. 3.11
Apply silicone to the Internal Trim channel as well as to valve wall. Do not apply silicone within 1½” of
outside edge line leaving enough space for the external trims to be installed.
Install panel
Dry fit the Lower(non-valve) wall to make sure it fits the top of the panel meeting the line on the wall
for the Design Strip as well as outside line on wall for the edge of the panel (pic. 3.12).
o Apply silicone to the Internal Trim channel as well as to valve wall but make sure to hold
the silicone 1 ½” short of outside edge line on wall for the trims to slot in later.