Installation Guide

22
Once all pieces are cut-to-size and ready to install, prior to applying silicone, Start by running a 4” scrap
piece of the trim behind the top and exterior edges in where the trims will be adhered to make sure
there are no blockages (pic. 5.3).
Pic 5.3
Dry fit all Exterior Trim Pieces to make sure all miters line up together and that they slide in behind the
panels with no issues and then cut to size, make sure to install any mitered pieces together so that they
can be adjusted for the best fit. Remember, the panels are inserted into a 3/8” channel on the trim
pieces…there is room for adjustments to accommodate a plumb & level finish (pic. 5.4).
Pic. 5.4 Pic. 5.5
o Start with top of Upper Back Panel and apply a bead of silicone into slot on trim piece and
Install trim (pic. 5.5).
o Take the Upper Level Trim Piece and apply a bead of silicone and into slot on trim piece.
Install trim piece making sure the inside miter is tight to upper back trim inside miter
o Take the Opposite Upper Level Trim Piece and apply a bead of silicone into slot on trim
piece. Install trim piece making sure the inside miter is tight to upper back trim inside miter
o Take the Outside Edge Trim and apply a bead of silicone behind into the slot on the trim
piece. Install trim piece making sure the outside miter is tight to upper side wall outside
miter.
o Take the Opposite Outside Edge Trim and apply a bead of silicone into the slot on the trim
piece. Install trim piece making sure the outside miter is tight to upper side wall outside
miter