Installation Guide

9
Pic 2.3
Pic. 2.4 Pic. 2.5
 If you are not comfortable cutting a straight line you can use a straight edge that is clamped
down and ride the saw along the edge. (pic. 2.5)
Remember the edges that are going into the trim channels do NOT have to be perfect cuts as
you have 3/8” covered in where the panel slides into the channel.
When cutting Design Strips to size, make sure to match up the corners in where they will butt
together (pic. 2.6).
Pic. 2.6
Once the wall is cut to specification, remove the top section for handling purposes. Be sure to write “TB”
on the backside for “Top Back”, this will allow you to identify where this panel goes during install.