Installation Guide

PACKING LIST

IMPORTANT NOTICES: For easy installation, please read all the instruction completely before beginning.

Before installing this product, make sure that water line trash is cleared to avoid blockage.

YOU MAY NEED

After you open this package, please check to ensure that all of the following items are included.

A-Faucet B-Mounting Nut C-Flexible Hoses(2) D-Allen wrench

Basin Faucet - 10118A1 & 10118A2

Optional accessories

Connect hot and cold water supply lines to the Water

Supply Valves.

INSTALLATION PROCEDURES

You should clean all the dirts from valve outlets.

Turning off the water supply valves. This is usually

found near the water meter. If you are replacing

an existing faucet, remove the faucet from the

sink and clean the sink surface thoroughly.

Install without Deck Plate. Make sure the O-RING

is placed onto the bottom of Base Ring. Install

faucet through hole in sink. From underside sink,

put Plastic Washer and Mounting Nut. Position

faucet on sink properly and tighten Mounting Nut.

If necessary, tighten screws using a adjustable

wrench until the faucet is firmly connected to the

sink.

1 2

Install with Deck Plate. Place a bead of plumber’s

putty between faucet and sink. Place Deck Plate

over the three holes of sink. From underside sink,

tighten Wing nut.

Make sure the O-RING is placed onto the bottom

of Base Ring. Install faucet through Deck Plate.

From underside sink, put Plastic Washer and

Mounting Nut. Position faucet on sink properly

and tighten Mounting Nut.

2A 2B

PAGE 1
Basin Faucet - 10118A1 & 10118A2 INSTALLATION PROCEDURES 1 2 PACKING LIST After you open this package, please check to ensure that all of the following items are included. A-Faucet B-Mounting Nut C-Flexible Hoses(2) D-Allen wrench B A You should clean all the dirts from valve outlets. Turning off the water supply valves. This is usually found near the water meter. If you are replacing an existing faucet, remove the faucet from the sink and clean the sink surface thoroughly.
PAGE 2
5B-1 Handle Removal Maintenance Valve Cartridge Removal Maintenance Unscrew Locknut. Make sure the Rubber Washer in the right position under Flange. Insert Pop-up Assembly into Sink drain Hole. From underneath, tighten with Lockset. As shown. Insert Flange with Washer through Sink drain Hole. From underside, thread Drain Body into Flange. Holding the drain body in position with Ball Rod Opening facing back, tighten Metal Locknut securely. Thread Drain Tailpiece into Drain body.