Technical Specifications

915mm

Thank you for selecting our product To ensure that your installation proceeds smoothly

BELLATERRA HOME

ASSEMBLY INSTALLATION

INSTRUCTIONS

804338

INTRODUCTION

read these instructions carefully before you begin also review the recommended tools and

materials section carefully unpack and examine your new plumbing fixture

. ,

ALL INSTALLATION PROCEDURES MUST COMPLY IN STRICT ACCORDANCE WITH

APPLICABLE LOCAL PLUMBING AND BUILDING CODES

Tools and materials Required

Most of the procedures require

the use of availabie from hard

ware and piumbing supply stores

it is essential that the tools and

matenals be on hand before work

is begun

.""*Dimensions shown for location of supplies and P trap are suggested

Roughing in Dimensions-

Adjustable wrench

Saber Saw

Basin Wrench

Plumbers Putty or

Ca ulking

Ch annel Lo cks

Pipe Wre chn

Putty Knif e

Tape

Measure

Tubing Cu tter

Ha cksaw

Drill

Re gular Screwdriver

Phillips Screwdriver

Level

804338

2000mm

78 3/4

PAGE 1
ASSEMBLY & INSTALLATION INSTRUCTIONS 804338 INTRODUCTION Thank you for selecting our BELLATERRA HOME product .To ensure that your installation proceeds smoothly , read these instructions carefully before you begin . also , review the recommended tools and materials section . carefully unpack and examine your new plumbing fixture .
PAGE 2
Step One:Use the track level bar,tape measure and pencil to mark holes in desired location.Having established the position,use drill to make holes.Use the hammer to insert anchors into the hole and screw in the screws.Finally put the mirror in place. Step Two:Place the vanity in position.Level vanity ensuring it is level with water outlets and piping.If the doors are out of alignment they can be fixed by adjusting the hinges.
PAGE 3
Install faucet and drain in accordance with manufacturer ' s instructions . Ensure all water supply and drain connections are tightened . Turn on water supply valves and water - test installation . A B Typical Drain Assembly Connect the trap to the drain assembly hand tight to check alignment . It may be necessary to cut off part of the tailpiece ( area " A " ) or part horizontal leg of the trap ( area " B " ) . Trap joints for watertight assembly .