User manual

37
6.5.3 Programming the terminal address
The terminals addresses are already programmed with address 1(VTA1), address 2 (VTA2) and
address 3 (VTA3), which is mandatory for the correct functioning of the system.
The programming is necessary if the addresses are changed by mistake during installation.
Any additional terminal connected in parallel must have the same address as the main terminal.
Step 1
Central unit SCU
PROG
Long press of PROG. The red LED turns on.
Step 5
Step 3
Step 4
For setting the RINGING VOLUME, short touches of
Each volume level, from 1 to 7, is signaled with increased
intensity of the selected ringtone.
BEEP
The maximum level is signaled with 2 x [ ]. With the
next touch, the volume restarts from level 1.
The last configuration remains set if is not touched
again for 3 sec.
For setting the RINGING DURATION, short touches of :
st BEEP
1 short touch of 1 x [ ] = the terminal will ring once
with the selected ringtone.
nd BEEP
2 short touch of 2 x [ ] = the terminal will ring
twice with the selected ringtone.
rd BEEP
3 short touch of 3 x [ ] = the terminal will ring 3
times with the selected ringtone.
th BEEEEP
4 short touch of 1 x [ ] = the terminal will
ring for 1 min. with the selected ringtone.
The last configuration remains set if is not touched
again for 3 sec.
CALL SETTINGS:
Terminal in stand-by
1. RINGTONE
2. RINGING DURATION
3.RINGING VOLUME
(for both call from
the outdoor panel and
intercommunication)
Step 1
BEEEEP
Simultaneous long press of and [ ].
The terminal goes in setting mode. You have 2 min. to
set all the 3 features, in whatever order you choose.
We suggest the following sequence.
Step 2
Terminal
VTA
Step 2
BEEEEP
Long press of [ ]. The terminal goes in programming.
BEEP
For terminal address 1 - 1 short touch of 1 x [ ].
BEEP
For terminal address 2 - 2 short touches of 2 x [ ].
BEEP
For terminal address 3 - 3 short touches of 3 x [ ].
For setting the RINGTONE, short touches of :
st
1 short touch of The terminal plays the 1st ringtone.
nd
2 short touch of The terminal plays the 2nd ringtone.
rd
3 short touch of The terminal plays the 3rd ringtone
and so on up to all 5 ringtones available. The last played ringtone
remains set if is not touched again for 3 sec.
Touch any of the , , keys to quit the setting mode. Or, it
will automatically quit after 7 sec. since the last operation.
Any error during programming is signaled with [ ]. The procedure must be repeated from Step 2.
BEEEEP
Step 3
PROG
Central unit SCU Press PROG. The red LED turns off.