Installation Guide

    
Use router or circular saw to create a kerf
at bottom of the door, along the center to
allow the tip of the T-shaped floor guide to
fit in between, to keep your door stable
and prevent the door bottom swinging
back and forth when you slide it open
and closed.
/”
/”
    
    
/”
The rubber ends are used to protect the
door from touching the rail when sliding
the door.
You need to drill holes on the door top side,
please drill the holes ½” away from the
edge of the door.
Then install the rubber ends on the door.
Hang the door over the rail.
    
Turn the rubber ends approximately 180
degrees so that they are stuck between
the door and the rail.
5 6
If your door’s thickness is less than 1/”,
please add some bolt washers or cut the
long door bolts to a suitable length to fit
the door.
    
* This manual is in general use.
Specific product type and ins
tallation requirements please
jump to page 8.
    
Insert door stoppers into rail.
Install door stoppers between A-B and C-D.
Door stopper is used to prevent the hangers
coming out of the rail.
A B C D
Do not screw it in
place at this stage
Install the hangers onto the door according
to the measurement in the pictures below.
Maximum door thickness is 1/”.
This manual is in general use.
Specific product type and installation
requirements please jump to page 8.
A
A