Installation Guide

4). Install the door and close in the frame opening using the door as a template. Adjust the uprights to
the door so that the gaps between the door and the frame are equal.
Picture 5.
5). Install the additional elements (Pic. 1) from the back into the guides of the base jambs. Start at
either end of any additional element. It may be necessary to apply a little force to do this. After all the
additional elements are installed and the gaps are set, they can be attached to the wall.
6). Install rubber seal around the perimeter of the door stopper, a lock and
adjustable magnetic strike plate (Pic. 6). Adjust latch to eliminate any door movement after locking. Add additional
fasteners as needed.
Picture 6.
Fasteners
Adjustable
magnetic strike
plate
Rubber Seal