Installation Guide

Preparation/Assembly
1
3
Installation
Par ts Breakdown
4
5
6
Steps 1-3
Steps 4-6
Parts Diagr am
2
Attach weights set to hose. For best results,
be sure the spray head is locked in the faucet
body, and attached the weights just above
the lowest part of the hose as it rises to the
spout. This will ensure pulling force all the way
into the faucet body.
Wrap supply inlets with pipe tape and connect
to water supply.
After installing faucet, remove pull-down spray and trun on water to remove any leftover debris. Re-assemble spray.
Please Note:
A. This pull-down faucet features two modes of operation. Aeration mode and spray mode (see illustration). To switch
to spray mode, Clockwise rotate spray head 90 .
Maintenance
Satet y Tips
Impor tant Points
Things You May Need
Your new laundry/bar faucet is designed for years of trouble-free performance.
Keep it looking new by cleaning it periodically with a soft cloth. Avoid
abrasive cleaners, steel wool and harsh chemicals as these will dull the finish
and void your warranty.
• If you use soldering for the installation of the faucet, the seats, cartridges
and washers will have to be removed before using flame. Otherwise,
warranty will be void on these parts.
• Protect your eyes with safety glasses when cutting or soldering water
supply line.
• Cover your drain to avoid losing parts.
Prior to beginning installation, turn off the cold and hot water lines and open
the old faucet to release built-up pressure. When installing your new faucet,
tu
rn the connector nuts finger-tight, then use one wrench to anchor the fitting
and a second wrench to tighten the nut one additional turn. Connections that
are too tight will reduce the integrity of the system. Wrap all threaded connections
with Teflon tape available at your local hardware or plumbing supply store.
Always wrap in a clockwise direction. The fittings should be installed by the
State-licensed plumber.
All installations can vary depending on how your previous faucet was installed.
Necessary supplies to install your faucet are not all included; however, they are
available wherever plumbing supplies are sold. When choosing your installation
supplies, make sure they are IAPMO and/or CSA approved products.
Shut off main water supple before installation.
Place new faucet in position on sink. From
under sink, thread nuts onto faucet. Tighten nuts.
o
Attach lower end of spray hose to central supply tube in facuet.
Index Button-Cold/Hot
Metal Handle Assembly
Retainer Nut & Washer
Ceramic Disc Cartridge - Cold
Ceramic Disc Cartridge - Hot
Putty Plate
Lock Nut Set
Hose Guide
Hand Spray w/Check Valve
Hose Adapter Assembly
Supply Hose
Weight
When installing flexible hose, please notice: there should be no torsion or
deformation; do not fold into shape V or L; do not use if there is any crack
or deformation.
•
installatio n
A
Aeration mode Spray mode
Belle Forêt
c o l l e c t i o n