Technical data

The clock on this product has two modes
of operation, fully automatic or semi
automatic. This product is intended for
use on the semi-automatic mode only. If
for some reason this mode has not been
pre-set already, the following procedure
shouldbeusedtosetittothismode:-
1. Turn the power off to the appliance for
30 seconds or more, then turn the power
on.
2.Withintherst6secondsofturning
the power on, press the function button
for 1 second.
3. The operating mode “P2” can then be
selected using the plus or minus buttons.
4. The clock has now been set to semi-
automatic mode, any power fail situations
will not change the selected mode.
The programmer buttons
The ‘function’ button in the centre is used
for setting the minute minder and setting
up the automatic cooking. See below for
details.
To set the time of day
When the power is turned on to the ap-
pliance, the time of day starts from 0.00.
Press and release the (minus)and
(plus)buttonssimultaneously.Set
the time of day, eg 2.00 with the
and buttons while the ‘dot’ between
thehoursandminutesisashing.
To select an alarm tone
Press and hold the button (minus)
buttontolistentorsttone.Releasethe
button and press it again to listen to the
second tone, etc. Releasing the button
after the tone has sounded will automati-
cally select that tone.
Setting the minute minder
Press and release the function button.
The minute minder bell symbol will appear
andashonthedisplay.Usethe
plus
and minus buttons to set the required
alarm time. After setting, the display will
revert to show the time of day and the
bellsymbolwillstopashing.Pressingthe
function button will display the minutes
remaining. If the time has counted down
to the last minute, the remaining seconds
are shown. The tone will sound at the end
of the time set. To cancel the tone, press
the function button.
USING THE CLOCK/PROGRAMMER - GAS