Technical data

Installing Your Cooker
Fitting the plinth (if applicable)
If your appliance has a storage drawer at the bottom,
you access the required holes through the base of the
drawer after lifting the mat.
 Open the appliance doors, and loosen screw A located
on bracket (2). Do not remove this screw entirely.
 Insert screw B, through slot (3) and screw into the small
hole at the bottom of bracket (2).
Make sure that the plinth cover is flush to the appliance,
but not over tightened.
Fitting the splashback (if applicable)
 Remove the screws from the rear of the hotplate vent.
 Locate the splashback in position so that all the fixing
holes are in line with the holes in the rear of the hot-
plate vent.
Re-fit screw into holes to secure the splashback in place




B
A
(1)
(2)
(3)
Y
Door
Plinth cover
Oven cavity
.
.