Technical data

installation
Makesurethattheexible
connector does not block the cooling
fan inlet.
4. Flexible connections should comply
with BS 669.
Parts of the appliance likely to come into
contactwithaexibleconnectorhavea
temperature rise of less than 70°C.
5. Rigid connections must be accessible
to disconnect for servicing.
Cut a 150mm square hole in the right
hand rear corner of the support shelf for
the supply pipe.
6. Make sure all connections are gas
sound.
Step 3 : Connect to the electricity
supply
Warning: This appliance must be
earthed.

Theexiblemainsleadissuppliedcon-
nected to a BS 1363 fused plug, the plug
isttedwiththecorrectfuse.
Replace only with a fuse of the same rat-
ing and type.
The wires in the mains lead are coloured
inaccordancewiththefollowingcode:
Green and yellow = Earth,
Blue = Neutral,
Brown = Live.
As the colours of the wires in the mains
lead for the appliance may not correspond
with the coloured markings identifying the
terminalsinyourplug,proceedasfollows:
1. The wire which is coloured green and
yellow must be connected to the terminal
markedE(Earth)orcolouredGreen.
2. The wire which is coloured blue must
be connected to the terminal marked N
(Neutral),orcolouredBlack.
3. The wire which is coloured brown must
be connected to the terminal marked L
(Live),orcolouredRed.
The plug and socket must be accessible
after installation. Should the mains lead of
the appliance ever require replacing, this
mustbecarriedoutbyaqualiedelectri-
cian who will replace it with a lead of the
same size and temperature rating.
Important:-ensurethatyourouteall
mainsandelectricalcablesandexible
tubing well clear of any adjacent heat
source.
Under no circumstances should the mains
electric cable be allowed to come into
contactwiththeverticalovenuetubes
on the rear of the appliance.
E (Earth)
Green/Yellow
N (Neutral)
Blue
L (Live)
Brown