User manual

8
Cabinet Construction For Your Appliance
The sizes of the unit for installing the appliance under
a worktop or in a column unit are shown in figure.
To provide adequate ventilation, there must be
appropriate ventilation opening; the panel to which
the oven is fitted should have a gap of at least 70 mm
at the rear.
The unit panels next to the appliance must be heat
resistant. In the case of veneered wood units, glues
must be resistant to a temperature of 120°C.
Fitting Your Appliance
Fit the appliance into its surround (beneath a work-top
or above another appliance) by inserting screws into
the 4 holes that can be seen in the frame of the oven
when the door is open.
Note:
Your appliance must be mounted on a flat surface for
the full width and depth of the product
Connect Power Supply Cord
 Pull open terminal board cover at rear panel of
appliance.
 Fit wires through on terminal board and make
connections to terminals.
 Engage wires into plastic clip. Secure plastic clip
with supplied screws.
 Close the terminal board cover.
Mounting Screws
Plastic cli
p
Plastic clip
Securing