20130902 issue 1 啊哈 Slim Line Range Hood Installation and User manual Content Safety instructions---------------------------------- 2 Product description--------------------------------- 4 Operation mode-------------------------------------- 5 Installation--------------------------------------------- 6 Start using the range hood------------------------ 10 Maintenance and cleaning-------------------------11 Warranty------------------------------------------------ 12 For warranty service call 1300 373 199
Safety Instructions This manual explains the proper installation and use of your range hood, please read it carefully before using even if you are familiar with the product. The manual should be kept in a safe place for future reference.
Safety Instructions Never to do: Always to do: z This range hood cannot be installed for outdoor use. z z It is prohibited to fit the range hood over a solid fuel applicable regulations concerning discharge stove of exhaust air are fulfilled. z z z z This appliance must not be connected to a chimney z Attention should be given to ensure that any This appliance should be installed and or vent flue which is in use.
Product Description Accessories Description Picture QTY Installation & User Manual 1 Outlet( diameter 120mm) 1 Dry wall anchors plugs 6 Outlet cover 1 Screw(ST4x30mm) 6 Component list: 1. Outlet(diameter 120mm) 2. Main body 3.
Operation Mode Your range hood can be operated in two optional modes, choose the mode suitable for your kitchen before installation. Air Exaction Air Recirculation For air exaction mode, a For air recirculation mode, ducting kit is required, the charcoal filter is a must to air is drawn in and cleaned eliminate cooking smells. by the grease filters and The air is drawn in and directed outside. cleaned first by the grease Ducting must be vented to filters and then charcoal outside atmosphere.
Installation Dimensions: *Width data please refer to page 4 Installation: Warning: Check that the installation complies with the standards of local building, gas and electrical authorities. Before connecting to the mains supply ensure the mains voltage corresponds to the voltage on the appliance rating plate inside the range hood. When installing the range hood, make sure you adhere to the minimum and maximum distances from the range hood base to the cooktop hob surface.
We provide two options to install your range hood, against wall (method A) or into cabinet (method B), choose what kind of method you want and then follow up corresponding instruction. A: Install against wall 1. Using a spirit level mark a vertical centre line on the wall where the hood is to be positioned, and a horizontal line where the hood base will be.
electrical hazards Fit the outlet and flexible exhaust pipe* on top of range hood body.
B: Install into cabinet 1. According to below drawing to determine where want to place the range hood, and drill 4 holes with 4mm diameter at the hanging board of your cabinet. 545mm(60cm hood), 845mm(90cm hood) 35.5mm 75.75mm 215mm 2. Fit the outlet on top of range hood body. 3. Install the range hood onto the bottom of cabinet board, insert 4pcs Screw(ST4x30mm) into the holes and fasten.
Start Using Your Range Hood Push button 0 Off button It’s used for turning off the fan. Low Speed button It’s used for Ventilation on the kitchen. It is suitable for simmering and cooking which do not make much steam. Medium Speed button Airflow speed is ideally for ventilation in standard cooking operation. High Speed button When high density of smoke or steam produced, press high-speed button for highest effective ventilation.
Maintenance and cleaning Caution: The mesh filters can be cleaned either by hand or in • Before maintenance or cleaning is carried out, the the dishwasher. After cleaning ensure that the filters range hood should be disconnected from the main are completely dry before refitting. power supply. Ensure that the range hood is switched - By hand: Soak in warm water and a neutral off at the wall socket and the plug removed. washing up liquid.
WARRANTY 1.1 In this warranty: 1.1.1 Australian Consumer Law means the law as set out in Schedule 2 of the Competition and Consumer Act 2010; 1.1.2 Company means GSM Sales Pty Ltd ABN 53 007 682 475 of 142-144 Fullarton Road, Rose Park SA 5067. Telephone 08 8122 2390. Email admin@gsmsales.com.au; 1.1.3 Consumer means a “consumer” as that term is defined in Section 3 of the Australian Consumer Law as the original purchaser of a Bellini product; 1.1.
1.8 You must provide proof of your purchase of the Bellini product and the date of purchase in order to obtain the benefit of this warranty. 1.9 If you live outside the service area of the Company or one of its service agents, this warranty does not cover the cost of transport of the Bellini product for service nor the service agent’s traveling costs to and from your home. 1.