User's Manual

Please read further in the Garvan Smoke Alarm instruction manual.
Test Bellman Visit Smoke Alarm Transmitter Unit using button with indicator lamp
The smoke alarm has a test button (2) with a red indicator lamp. This lamp ashes once or twice
per minute to indicate that the battery is correctly connected and providing enough power to
activate the alarm. To test the function of the Smoke Alarm Transmitter Unit just press the test
button for ve seconds until the smoke alarm transmits to a Bellman receiver and the alarm
sounds. The receiver will then respond with sound/light or vibration/light depending on the type
of receiver.
Location
Installation
CZGBDKESFIFRHUITNLNOPLPTSEYU
Loosen the mounting bracket by pressing the lock with a screwdriver and pushing the Smoke
Alarm in the opposite direction. Connect the battery. Press the test button for a few seconds until
the alarm sounds and the Bellman Visit receiver responds. If this occurs, the unit is working prop-
erly and could now be installed. First, attach the mounting bracket on the ceiling with the screws
provided. Insert and slide the Smoke Alarm on the mounting bracket until it locks.
Install Remove