User's Manual

Service and support
If your smoke alarm fails to work after you have read the sections 'Installation, Testing
monitoring and maintenance' and 'Troubleshooting', please contact the Bellman & Symfon
Service Center for North America (see the address at the end of this leaet) and get an
RMA# (Return Merchandise Authorization). Put the smoke alarm in a padded box with
the battery disconnected and state the nature of the fault, where the smoke alarm was
purchased and the date of purchase. Ship to the address given at the end of this leaet
using the shipping company of your choice (UPS, USPS, FedEx).
Warranty conditions
Bellman & Symfon guarantees this smoke alarm (excluding the battery) for 2 years from
date of purchase against any defects that are due to faulty materials or workmanship. This
guarantee only applies to normal conditions of use and service, and does not include dam-
age resulting from accident, neglect, misuse, unauthorized dismantling, or contamination
howsoever caused. This guarantee excludes incidental and consequential damage. Further
the warranty does not cover Acts of God, such as re, ood, hurricanes and tornadoes. If this
smoke alarm should become defective within the guarantee period, it must be returned
to Bellman & Symfon, with proof of purchase, carefully packaged, with the problem clearly
stated. We shall at our discretion repair or replace the faulty unit.
Bellman & Symfon shall not be liable for any incidental or consequential damages caused
by the breach of any express or implied warranty. Any implied warranty of merchantability
or tness for purposes is limited to the duration of the above warranty period. This warranty
gives you specic legal rights and you may also have other rights that vary from state to
state. Some states or jurisdictions do not allow the limitation or exclusion of incidental or
consequential damages, or limitations on how long an implied warranty last so the above
limitation may not apply to you. Do not interfere with the smoke alarm or attempt to tamper
with it. This will invalidate the guarantee, but more importantly may expose the user to
shock or re hazards. This guarantee is in addition to your statutory rights as a consumer.
Bellman & Symfon makes no warranty, expressed or implied, written or oral, including that of
merchantability or tness for any particular purpose, with respect to the battery. The above
warranty may not be altered except in writing signed by both parties hereto.
FCC compliance statement
This device complies with Part 15 of
the FCC Rules. Operation is subject to
the following two conditions: (1) this
device may not cause harmful interfer-
ence, and (2) this device must accept
any interference received, including
interference that may cause undesired
operation.
FCC ID: 2APAKBE1284
Warning: Changes or modications
not expressly approved by the party
responsible for compliance could void
the user's authority to operate the
equipment.
Note: This equipment has been tested
and found to comply with the limits
for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference
in a residential installation. This equip-
ment generates uses and can radiate
radio frequency energy and, if not
installed and used in accordance with
the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or televi-
Service center
Bellman & Symfon Service Center
for North America
1081 West Innovation Drive
Kearney, MO 64060
USA
Call 1-877-720-3401 Toll Free
European oce
Bellman & Symfon Europe AB
Södra Långebergsgatan 30
436 32 Askim
Sweden
Phone: [phone]
E-mail: [e-mail]
sion reception, which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Industry Canada statement
This device contains licence-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development Canada’s
licence-exempt RSS(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that
may cause undesired operation of the device.
L'émetteur/récepteur exempt de licence contenu dans le présent
appareil est conforme aux CNR d'Innovation, Sciences et Développe-
ment économique Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) L'appareil ne doit pas produire de brouillage;
(2) L'appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d'en compromettre le fonctionnement.
This Class B digital aparatus complies with the Canadian RSS-210.
IC: 6693A-BE1284
This smoke alarm is certied to:
ANSI/UL217, CAN/ULC-S531, ANSI/UL539 and ULC/ORD-C539
For a complete Declaration of Conformity, please contact the Bellman &
Symfon European oce.
29 30