Operation Manual

Changing the radio key
If your Visit system is activated for no reason, there is probably a nearby system that triggers yours. In order to avoid radio
interference you need to change the radio key on all units. The radio key switches are located on the transmitters.
Here is how you change the radio key:
1 Open the transmitter cover and move any radio key switch to the up = on position to change
the radio key. See Changing the radio key for the relevant transmitter.
2 Press and hold the test button located on the bottom of the portable receiver until the green
and yellow Visit LEDs blink alternately. Release the button.
3 Press the test button/s on the transmitter within 30 seconds to send the new radio key.
4 All Visit LEDs on the receiver blink 5 times to show that the radio key has been changed. It then returns to normal mode.
Please note: All Visit units must be set to the same radio key in order to operate as a group.
1 2 3
4
x 5
Visit portable receiver
Accessories
The portable receiver can be complemented with the following accessories:
 BE1270 Bed shaker
Wakes you with vibrations if anything
happens while you are asleep. Connect
it to the receiver and slide it under your
pillow or mattress.
 BE9201 EU / BE9202 UK power supply
If your receiver has a xed place, you
can connect it to mains power and not
having to worry about batteries.
Connecting a speaker
On the receiver model BE1452, the bed shaker outlet is replaced with a 3.5 mm audio output that can drive an external
speaker. The speaker can be used to amplify the receiver audio signal further or to relay the audio signal to a nearby room.
BE1270
On
O