Datasheet

PRODUCT SPECIFICATION
REVISION: ECR/ECN NUMBER: DOCUMENT NUMBER SHEET No.
B
.1
EK2017-0028
PS-70094-001
5 of 11
DATE: CREATED / REVISED BY: CHECKED BY: APPROVED BY:
201
7
/
0
2
/
0
7
Kevin Miao
Ivanov
Wang
Ivanov
Wang
Form No.: QR-QP025-15 REV.: A
5.0 PERFORMANCE, TEST REQUIREMENT AND PROCEDURES SUMMARY
5.1 APPEARANCE REQUIREMENTS
Item Test Description Test Method
Reference
Standard
1
Examination of
product
Visual according to applicable quality
inspection plan.
Meet the requirements
of product
5.2 ELECTRICAL REQUIREMENTS
Item Test Description Test Method
Reference
Standard
2
Contact
Resistance
(Low Level)
Mate connectors: apply a maximum
voltage of 20 mV and a current of 100
mA. (Does not include wire resistance)
5 milliohms MAXIMUM
[initial]
3
Insulation
Resistance
Unmate & unmount connectors: apply a
voltage of 500 VDC between adjacent
terminals and between terminals to
ground.
1000 Megohms
MINIMUM
4
Dielectric
Withstanding
Voltage
Unmate connectors: apply a voltage of
{two times the rated voltage plus 1000
volts} VAC for 1 minute between
adjacent terminals and between
terminals to ground.
No breakdown;
current leakage < 5 mA
5 Temperature Rise
Mate connectors, measure the
temperature rise at the rated current.
The ambient condition is still air at 25°C,
Per EIA-364-70 method 2.
Temperature rise:
+30°C MAXIMUM
5.3 MECHANICAL REQUIREMENTS
Item
Test
Description
Test Method
Reference
Standard
6
Connector Mate
And
Unmate Forces
Mate and unmate connector (male to
female) at a rate of 25 ± 6 mm per minute.
(Per circuit)
8.0 N (1.8 lbf)
MAXIMUM insertion
force & 2.0 N (0.45lbf)
MINIMUM withdrawal
force (Tin plated)
5.6 N (1.26 lbf)
MAXIMUM insertion
force & 1.5 N (0.34lbf)
MINIMUM withdrawal
force (Gold plated)
7
Terminal
Retention Force
(in Housing)
Axial pullout force on the terminal in the
housing at a rate of 25 ± 6 mm per minute.
24.5 N (5.5 lbf)
MINIMUM retention
force