PRODUCT SPECIFICATION PRODUCT DESCRIPTION: USB TYPE C Connector PRODUCT NUMBER: 80239/80243/80245 series REVISI ECR/ECN A EK2015-0*** DATE: 2015/08/03 DOCUMENT NUMBER SHEET PS-80239-001 1 of 8 CREATED / REVISED CHECKED BY: APPROVED BY: Eric Bai Jerry Wang Larry Chen
PRODUCT SPECIFICATION 1.0 SCOPE...................................................................................…................2 2.0 APPLICABLE DOCUMENTS………………………….............…..…….....2 3.0 REQUIREMENT .......................... .…….…….... .…….... .……................
PRODUCT SPECIFICATION 1.SCOPE: 1.1 Content This product specification defines the product performance and the test methods to ascertain the performance of the USB TYPE C Connector which is designed and manufactured by Bellwether Electronic Corp. 1.2 Qualification Tests and inspection shall be performed in accordance with the requirements, tests and methods contained herein. All the inspections shall be conducted by using plan for the product drawings and the inspection these products.
PRODUCT SPECIFICATION 3.7.2 Packaging carton with products should be subject to falling test. 3.7.3 Other requirements see Bellwether’s packaging specification . 3.8 Test Description The product is designed to meet the requirements specified in section 3.9. Unless otherwise specified, all tests and measurements are to be performed at the following conditions: Temperature: 15℃ to 35℃. Relative Humidity: 25% to 85%. Atmospheric pressure : 86kPa to 106 kPa. 3.9. Test Requirements and Methods 3.9.
PRODUCT SPECIFICATION 3.9.8 Durability Comply with method EIA 364-09. Test sample are subjected to fully mate and unmate for 10000 cycles. The durability test shall be done at a maximum rate of 200 cycles per hour . The wrenching strength test shall be performed using virgin parts. Perpendicular forces (Fp) are applied to a plug when inserted at a distance (L) of 15mm from the edge of the Connector. These forces shall be applied in all four direction.iie., left,right,up, and down). 3.9.
PRODUCT SPECIFICATION minimum of 5 minutes). Humidity is not controlled. Perform 500 such cycles. Comply with method EIA 364-65,Class II A. duration:7-days, Options #1A and #1B as specified in EIA 364-1000.01. 3.9.17 Mixed Flowing Gas After the test, the sample shall pass the requirement of 3.9.1, 3.9.2 specification. High Frequence Characteristics Comply with method EIA 364 -108. This test ensures that the signal conductors of the USB Type C connectors have the proper impedance.
PRODUCT SPECIFICATION Figure 3-3. Differential Crosstalk between SuperSpeed Pairs REVISI ECR/ECN A EK2015-0*** DATE: 2015/08/03 Figure 3-4. Differential Crosstalk between SuperSpeed and D+/D- pair DOCUMENT NUMBER Figure 3-5.
PRODUCT SPECIFICATION Test Sequence 1 2 3 4 5 6 7 TEST GROUP TEST DESCRIPTION Visual Examination A 1,4 B 1,3 C 1 Low Level Contact Resistance 11 12 3 14 15 16 17 18 19 20 21 22 23 F G H 1 1 1 1 1 2,5,7 2,5,7,9 2,5,7 2,5,7,9,11 2,5,7,9 I 1,10 3,8 2,9 Insulation Resistance Contact Current Rating 2 Insertion Force 4 Extraction Force 5,7 3(50Cycles manually), 6(3Cycles manually Durability 10 E Dielectric Withstanding 8 9 D Wrenching Strength 3 3(50Cycles (50Cycles manually