Operator`s manual

Belshaw Bros., Inc.  www.belshaw.com  Phone [phone]  Fax [phone]
718L/724/734CG Gas Fryers TS MN-1143EN 5
Assembling the Frying
Screen Handles
(Be aware that you may be using detachable
handles rather than fixed handles, particularly
when making raised donuts using screens which
are placed inside a proofer. In this case, your
handles should NOT be attached to screens.)
Frying Screens come with handles and hardware
unassembled. When assembled the location of
the handles should be as follows:
 For Model 618L and 718L Fryers, center the
handles along the long sides of the screen.
 For Models 624 and 724, center the handles
along any opposing sides of the screen.
 For Models 634 and 734, center the handles
along the short sides of the screen.
To assemble Frying Screens, refer to Figure 1-3
opposite.
1. Install #10-32 Nuts (B) on threaded handle
rods (A).
2. Locate clips (D) on the screen (C). Center the
handles as listed above for each type of fryer.
3. Insert threaded end of handle (A) with handle
to outside as shown, making sure that the
spacer (E) is in place.
4. Install #10-32 nuts (F) flush onto threaded
end of handle (A)
5. Tighten #10-32 Nuts (B) locking handle
assembly to screen.
(Above: Figure 1-3)