Installation Guide

ManualsBrandsBelvedere ManualsBathOmega Wall-Mount Bathroom Sink with Fixtures and 403 Vacuum Breaker in Black

3. If your bowl is equipped with a Vacuum Breaker,

remove the two

(2) Hex-nuts and

Washers from the

Vacuum Breaker

Pipes. Place the

Vacuum Breaker

Pipes through

the holes in

the bowl as

shown.

Secure the

Vacuum Breaker

to the bowl with

the Washers

and hex-nuts.

DO NOT

OVERTIGHTEN.

Shampoo

Bowls

2100 AND 2800 ACRYLIC BOWLS

ACRYLIC SHAMPOO BOWL

WITH VACUUM BREAKER

AND MODEL 522 FIXTURE

INSTALLATION AND PLUMBING

NOTE: To familiarize yourself with the various

components, please read instructions through

before starting.

1. Attach the Fixture to the Bowl according to

the instructions packed with the Fixture.

NOTE: Install the vacuum breaker as shown.

If the vacuum breaker is installed backwards,

it will interfere with the Whiz Spray.

PAGE 1 of 3

BOWL WITH VACUUM BREAKER

4. Connect one end of the Fixture Hose to the

inlet side of the Vacuum Breaker. Connect

the other end to the Fixture Tailpiece.

Attach the Spray hose connector to the

Vacuum Breaker outlet.

2. If your bowl is not equipped with a vacuum

breaker, attach the Spray hose connector

to the Fixture Tailpiece and insert two plastic

plugs in the holes.

2100

2800

Belvedere U.S.A. Corporation

A wholly owned subsidiary of The Wella Corporation

One Belvedere Boulevard, Belvidere, Illinois 61008

Printed in U.S.A. E.C.O. 8021 4001022 Rev. 10-03

SPRAY

TAILPIECE

VACUUM

BREAKER

INLET

OUTLET

FIXTURE HOSE

SPRAY

TAILPIECE

VACUUM

BREAKER

GASKET

NUTS

Summary of content (3 pages)

PAGE 1
Shampoo Bowls 2100 AND 2800 ACRYLIC BOWLS ACRYLIC SHAMPOO BOWL WITH VACUUM BREAKER AND MODEL 522 FIXTURE INSTALLATION AND PLUMBING NOTE: To familiarize yourself with the various components, please read instructions through before starting. 2800 2100 1. Attach the Fixture to the Bowl according to the instructions packed with the Fixture. 2. If your bowl is not equipped with a vacuum breaker, attach the Spray hose connector to the Fixture Tailpiece and insert two plastic plugs in the holes. 4.
PAGE 2
5. Install the wall bracket so that the offset is 31-1/4” from the finished floor. Be sure the bracket is level! Leave the bracket slightly loose. Use the attached BRACKET template and mark all five bolt holes. (The bracket height shown is suggested to obtain the 31 1/4” neckrest height suitable for most stylists. However, the bracket height may be varied to suit personal preference.) INSTALLING THE DRAIN ASSEMBLY 6.
PAGE 3
ROUGH-IN PLUMBING SPECIFICATIONS. This shampoo bowl is designed for optimum comfort when the bowl neckrest is at 31”. However, this may vary to suit individual salon owners. SEE NOTE BELOW. Belvedere Recommends a bowl neckrest height of 31”. To mount the bowl at this height, simply locate the bowl bracket height as shown in these specifications. CLEANING INSTRUCTIONS TOP VIEW Use non-abrasive soap and water, Review the label instructions before applying any cleaner to the acrylic surface.