HAVEN 3000 OWNER’S MANUAL
TABLE OF CONTENTS PRODUCT INFORMATION Safety Precautions..................................................4 Parts................................................................................6 Product..........................................................................7 Dimensions.................................................................8 Remote Control........................................................9 PRODUCT INSTALLATION Seat Installation.............................................
SAFETY PRECAUTIONS IMPORTANT SAFEGUARDS • When using electrical products, especially when children are present, basic safety precautions should always be followed. READ ALL INSTRUCTIONS BEFORE USING • Do not overtighten any connections. WARNING - TO REDUCE THE RISK OF BURNS, ELECTROCUTION OR INJURY TO PERSONS: • Close supervision is necessary when this product is used by, on, or near children. • Use this product only for its intended use as described in this manual.
PARTS PRODUCT Deodorizer Cartrige 6 7
DIMENSIONS Elongated 8 REMOTE CONTROL Round 9
SEAT INSTALLATION 1. Remove the seat from the existing toilet body. 2. Install the T-Valve. 3. Fix the catch plate onto the toilet. 4. Push the main body toward the catch plate completely. Cone washer • Release the nuts, and then remove the seat and cover. • Store the seat in a proper place for future use. • Turn off the water. • Remove the existing water hose and then install T-valve to the bottom of the toilet tank.
SEAT INSTALLATION (CONT.) 5. Connect bidet hose. • After installing the T-valve, connect the supplied bidet hose from the center of the T-valve to the bidet. • Connect the toilet hose to the bottom of the T-valve. 6. Deodorizing Cartidge • Insert the deodorizing cartridge into the bidet body. 7. Plug it in! • Plug in and be sure that the nozzle extends and retracts when powered on. • Do not plug the power cord in with wet hands. Risk of electric shock. 8. Turn on the water and check for leaks.
HOW TO USE 1. Sit On The Toilet Seat 4. Massage • Be sure to sit on the seat sensor. If the sensor is not occupied, all functions will not open. 2. Wash, Bidet, Turbo • Press the Massage button after activating a cleansing function for a pulsating effect. 5. Child Function • Select this function to fully extend the nozzle and activate a low pressure and low temperature wash. • Selected function can be used as described.
HOW TO USE (CONT.) 11. Night Light • Hold the “+” button for 3 seconds while the seat is not occupied to turn on/off. 12. Automatic Tank Draining • The tank will automatically drain and refill if the seat is not used for 48 hours. Hold the Stop and Water Temp buttons for 3 seconds to turn on/off. 13. Sitz Bath • Press the nozzle cleaning button after selecting a cleansing function to activate a 5 minute low pressure wash. 14.
MAINTENANCE & CLEANING REMOTE CONTROL INSTALLATION Cleaning Instructions 1. Remove the adhesive protection. • Avoid using harsh cleaners to preserve the plastic material of the bidet seat. Wipe the surface with a damp cloth or neutral cleaning solution. Do not splash water onto the power plug. • Remove the adhesive protection to attach the remote control bracket to the wall or other surface. • Clean and dry the area thoroughly before attaching the brackets. Screen Filter Cleaning 1.
REMOTE CONTROL INSTALLATION (CONT.) TIPS & SPECIFICATIONS 3. Battery life. • When the batteries have reached the end of service life, all LEDs (5 points) will blink. Replace the batteries with new AAA batteries. • Do not use old and new batteries together. This could cause damage or failure of the remote control. Rated voltage AC 120V, 60Hz 870W Power cord length 1.2 m Recommended inlet water pressure 99~106.6 psi Wash Dry 0.13~0.
TROUBLESHOOTING & WARRANTY PLEASE CHECK THE FOLLOWING POINTS BEFORE REQUESTING REPAIR SERVICE.
Thank You 300 Mill Street Sheboygan Falls, WI 53085 T: 920.467.4621 Bidets@Bemismfg.com ToiletSeats.
