Installation Sheet

20 21
TIPS & SPECIFICATIONS
ITEM HAVEN 3000
Rated voltage AC 120V, 60Hz
Max. Power consumption 870W
Power cord length 1.2 m
Recommended inlet
water pressure
99~106.6 psi
Wash
Wash Volume 0.13~0.21 gal/min
Heater Capacity 800W
Heated
Seat
Temperature Control 4 levels (off-low-middle-high)
Heater Capacity 55W
Dry
Temperature Control Room temp. - 122F
Heater Capacity 250W
Deodorization Catalytic Deodorization
Feed water temp.
tolerance range
37~95°F (recommended 54~95°F)
Usage room temp.
tolerance range
37~104°F (recommended 50~95°F)
Dimension
Elongated 15.9” (406) x 20.8” (528) x 7.0” (178)
Round 15.9” (406) x 19.5” (496) x 7.0” (178)
Weight
Net
Weight
(Gross
Weight)
Elongated 10.5 lb (15.2)
Round 10.2 lb (14.9)
REMOTE CONTROL INSTALLATION (CONT.)
3. Battery life.
• When the batteries have
reached the end of service life,
all LEDs (5 points) will blink.
Replace the batteries with new
AAA batteries.
• Do not use old and new
batteries together. This could
cause damage or failure of the
remote control.
4. Test unit out.
• After replacing the batteries, ID of the unit will be reset to “00”
• If you have multiple bidet seats and want to change the remote
ID, please see below.
1. Press Nozzle Control “ “ for 3 seconds. The indicator of “Nozzle
Cleaning” blinks and the unit is ready for ID setting.
2. Set the ID by pressing Power Control “+” or “-” (1-5 IDs available)
3. Press “Stop” to save the ID. The main unit will be synchronized
simultaneously.