Owner`s manual

Page 5
7. Tighten the router table.
Tighten the bolts gradually and evenly. Use a soft tipped
mallet to lightly tap the table surfaces. If your router table is
not flat with your table saw's table, you may need to shim it.
Use paper or brass shims. The tolerances of your ProMAX
are probably much higher than those of your table saw's.
Slight inaccuracies in alignment rarely pose a significant
problem.
6. Lift the router table into position.
Install the bolts while a friend holds the table in position.
Just snug the bolts for now. Make absolutely certain both
surfaces are smooth, flat, and free of burrs before
mating the two tables together!
5. Install the insert plate leveling screws.
Install, as shown. Use the 1/4-20 x 1" set screws and 1/4" nuts.
You will adjust and tighten these screws in steps 8 and 9.
4. Three bolt applications.
This pattern always uses the heavy rectangle washers on each
bolt. Delta brand uses the 7/16-20 x 1-1/2 hex bolts. Most others
(imports) use the M10 x 1.5 x 40mm hex bolts. If your bolt size
was not mentioned you must purchase your own. Only use grade
5 bolts.
4
5
6
7
7/16-20 x 1-1/2"
hex bolts
Thread the nuts
onto the 1/4-20 x 1"
set screws.
M10 x 40mm hex
bolts (8.8 is stamped
on the head)
Use the heavy rectangle washer
on all three bolts!
WASHER ORIENTATION
(bottom of table)