Owner`s manual

Page 6

10. Adjust miter gauge track to fit your miter gauge.

First test-fit your miter gauge into the track. If it's too tight,

squeeze the gib against the front wall of the miter track with a

pair of Channel Locks. Use something to prevent marring the

aluminum. Next, install the (12) 1/4-28 x 1/2" set screws.

Tightening the screws will deflect the gib into your miter gauge.

Tighten all screws uniformly and gradually until the desired fit is

achieved. Miter gauge NOT INCLUDED.

11. Install the accessory/miter gauge track.

Use the (3) 1/4-20 x 5/8 low head cap screws. Tighten with the

1/8" hex wrench.

1/4-28 x 1/2"

set screw

This miter track ONLY fits standard 3/8" x 3/4" miter

gauge bars. Wax the slot and bar to reduce wear.

front

wall

gib

8. Adjust leveling screws until insert plate is flush.

Install the insert plate into the routertop. Adjust leveling screws

until the plate is flush with routertop. You will mount your router in

step 16.

9. Tighten the levelers.

Hold the leveler with the 1/8" hex wrench, and use your 7/16"

wrench to tighten the nut. This will prevent the assembly from

moving. Be sure to hold the hex wrench securely when tightening

the nut. It may be necessary to fine tune the adjustment after

installing your router.